Hi,

New to the forum and my first post here. Newbie from Finland.
I just got my new quad assembled and was about to do the maiden flight when I ran to this problem.
The throttle goes crazy and only way to shut it down is to disarm the quad.
Does the same regardles the mode I'm using: Air, horizon and angle.
Tried disabling the anti gravity mode but that didn't help.
In receiver tab everything works as it should.
Please help me to get this thing flying. Thank you!


Here's a video I made of the issue: 

Pitch and roll works fine but any throttle input makes it go crazy: 

turtle mode?? also, are the props on the quad when u do this??

Turtle mode disabled. No props on, but when I tried it with props outside it did similar thing. Leaned on it's side, didn't go up and the throttle was crazy.

strap it down, put props on, check motor direction, make sure props are on properly(correct direction). I know this sounds "basic" but I cant count how many times I rushed and missed one if not both of these..
The 3d model in betaflight corrisponds with the quad as u manipulate it? (orientation)

I just realized your manipulating the quad with ur controller, AND its connected to BETAFLIGHT. I thought there was a "failsafe" to keep someone from launching their quad as its tethered to the computer

Done all that. If you've seen the videos I uploaded, the throttle just goes berserk when applied even a little bit. Revs go up and there is no control after it. Pitch and roll it works as it should when checking in betaflight.