Did the tinysled mod.. it works GREAT... was getting terrible video noise powering the unify nano from vbat so I switched it up and am now powering it from the old vtx power pads just like the tinysled board wants.. bridged the pads to set the tinysled to 5v and everything works great!  Question is .. does anyone know what the actual rated output of the 5v rail on the TH2FS AIO board is?  The way I figure it the TBS stuff is drawing around 700mah...wondering if im going to pop the AIO board. 

Anyone done this setup before and have real world experience or know the actual factory rating of the 5v rail on the TH2FS AIO board?  

Thanks in advance!

I have multiple tinyhawks, and have done multiple upgrades.. haven’t done the tiny sled and unify yet.. but I’ve run several differently vtxs (diamond dvr, and eachine nano) one maxed at 200 the other at 600.. all powered from the original vtx pads.. no issues so far..
And that is also with a baby ratel camera AND a external Frsky rx...

I did the Tinysled mod with tbs tracer and tbs unify pro32 nano vtx. I was a little worried about burning it out too, so did the direct to battery voltage and bridged those pads. I haven't had any voltage problems.

(26-Mar-2021, 01:22 AM)Rob Axel Wrote: I have multiple tinyhawks, and have done multiple upgrades.. haven’t done the tiny sled and unify yet.. but I’ve run  several differently vtxs (diamond dvr, and eachine nano) one maxed at 200 the other at 600.. all powered from the original vtx pads.. no issues so far..
 And that is also with a baby ratel camera AND a external Frsky rx...

that's what I wanted to hear!  Thanks!

---

(26-Mar-2021, 06:36 AM)Timmyhawk 2 Wrote: I did the Tinysled mod with tbs tracer and tbs unify pro32 nano vtx. I was a little worried about burning it out too, so did the direct to battery voltage and bridged those pads. I haven't had any voltage problems.

I did that first but got really bad noise in the video feed when I armed... too much noise from the ESCS/Motors

Strange, mine doesn't get any interference from the motors or esc. My video feed is clear as a digital feed I reckon except when I go around the back of the house and I'm facing the wrong way (that's on 400mw). I did mess up my sled a bit though overheating a few pads and then ran wires to fix the problems, so maybe that's why mine may be different, IDK?

I'm still using the Emax box goggles with my TinyHawk 2 and TH2 Freestyle. I'm using the Lumenier AXII Micro's on my quads. I put the AXII Duo patch, and the AXII Double LR omni on my Emax goggles. Yes, I have twice as much in antennas than the goggles are worth, but it made a -huge- difference. I guess this is kinda impertinent to the original question, as it's still with the original 200mw VTX, but I figured I'd share. Good antennas make a big difference.

I’ve done the sled upgrade and used Vbat. No problems