I have gotten a KingKong/LDARC Tiny 6 micro quad and have connected it to betaflight. I have bound it to my transmitter (spektrum DX6) and the stick inputs appear on betaflight. However, I cannot get the motors to spin/arm. I have already set my arm and flight mode switches but the motors do not spin. In betaflight's 'motor' section, there is an option to power up the motors and that also does not work. I have also replaced the motors with new ones and they too do not work.
Do you think the fc is spoilt? If not, could you help me solve this problem?

Thanks!
Irwin

Hi Irwin, firstly welcome to a brilliant forum for FPV!

Check the "receiver tab" of betaflight and see if the "stick low threshold" is very low ie. between 1000 and 1025. if your TX throttle doesn't go lower than the "low stick threshold" then you will not be able to arm.

Oh right, you don't get movement using the motors tab. Sorry for the obvious question but, did you check the slider in the "motors tab" to confirm "props are removed" before trying it?

If this all seems ok, it sounds like your board is bad I'm afraid.