This forum uses cookies

Aer0baticCat · 16-Jan-2022, 06:05 AM

I'm working on making a TBS caipirinha 2 using a wing layer. This is my first long-range plane build so there's probably something I'm doing very wrong but in any case, I can't get my Tango 2 to bind with the 8ch tbs crossfire I'm trying to use with it. I've updated the Tango 2 to the latest firmware, but I still can't get them to bind. If anyone has any ideas on what I might be doing wrong that would be great.

kafie1980 · 16-Jan-2022, 08:47 AM

Did you try the Emergency firmware procedure:

(16-Jan-2022, 03:40 AM)SnowLeopardFPV Wrote: Try the emergency recovery procedure below, then update the firmware to V6.13 on both your Crossfire TX and RX using TBS Agent M (HERE).

Hold the “bind” button

Power up the receiver
The led starts to flash rapidly

Release the button
for about 1-2 seconds

Push and hold the button again
The green led starts to flash in a double-pattern. When it starts to flash rapidly again, you can release the button

Wait till the update is finished
When the receiver finished the update it will flash slowly

Now the receiver is ready to bind
You should power-cycle the receiver to avoid issues

Aer0baticCat · 19-Jan-2022, 01:36 AM

Thanks! I'll try that.

Login
Email:
Password:	Lost Password?
	Remember me

Possibly Related Threads...
Thread		Author	Replies	Views	Last Post
	Binding reciever g-rx8	Smokie	0	516	12-Mar-2021, 05:56 PM Last Post: Smokie