i cant get my receiver and transmitter to work with this new build i am doing and i know i have the reciever and transmitter linked because i've swapped the reciever onto a diff fc and it works accordinlgy so i think it is a wrong setting somewhere but anyway i am using the fport for rsxr and i just need to know what in the ports tab to select i think but speedy bee tech support has been no help. i have it landed on the t1 tab on my fc. i will post dump shortly from betaflight. please spread your knowledge if ya got any about my prob at hand.. thanks

  BTFL_cli_speedybee_20200416_174144.txt (Size: 27.4 KB / Downloads: 225)
  BTFL_cli_speedybee_20200416_174144.txt (Size: 27.4 KB / Downloads: 225)

I'm assuming you have the S.Port pin on the connector of the R-XSR wired to the T1 pad on the Speedybee F7 FC because that is the UART you have "Serial RX" switched on for. If that is the case then just run the following commands in the CLI and you should then get stick movements...


On a related note, you seem to have SOFTSERIAL1 set up and configured for both MSP and SmartPort which you don't need if you are running FPORT. Did you configure that yourself or was it already pre-configured on the Speedybee F7 flight controller?

(17-Apr-2020, 12:04 AM)SnowLeopardFPV Wrote: I'm assuming you have the S.Port pin on the connector of the R-XSR wired to the T1 pad on the Speedybee F7 FC because that is the UART you have "Serial RX" switched on for. If that is the case then just run the following commands in the CLI and you should then get stick movements...

Code:

set serialrx_halfduplex = ON
set serialrx_inverted = ON
save

On a related note, you seem to have SOFTSERIAL1 set up and configured for both MSP and SmartPort which you don't need if you are running FPORT. Did you configure that yourself or was it already pre-configured on the Speedybee F7 flight controllethank 

thanks again! it worked but to answer your question i think the only thing i had changed up stuff in the tab section was the vtx peripherals to irc tramp and yea i have it to the t1 padand i tried the halfduplex on right before you posted on here but i didnt have the serialrx inverted on......thank you once again for getting me back in the air again!