This is a rehab of an old QAV250 which was a little beaten up. I ripped out the old PDB, CC3D FC, and VTX and replaced with a HGLRC AIO board to save space, which allowed me to replace the existing standoffs with 16mm replacements. I don't have any build pics but I can get a couple pics of the wiring with the top off if you like.

I do need to go back and trim the motor wires, but otherwise I'm happy with it. Not high spec, but it flies nicely.

* Generic 2300kv motors (from a prototype I had built)
* HGLRC F4 V6
* 30A LittleBee ESCs
* Turnigy IA6B receiver
* Dronin firmware

I'm working on another QAV250 rebuild at the moment using an Omnibus F4 stacked on a 4 in one ESC, with 20mm standoffs. Will post that once finished.