15-Dec-2020, 03:10 PM
Hello Guys, Hope any of you can help me with my dilemma. 3 weeks ao I got my first 3D printer an Ender 3 V2. It prints PLA very well and I can print small parts on TPU BUT when all turns complicated and bad when I try to print medum sizes TPU parts such as the GoPro mounts. I'm using Sain Smart TPU filaments. I'm also using Cura 4.8 and retractions enabled. Temp 195 to 200 and bed 50. infill 65%
This has been very frustrating after so many hours, attempts and money wasted.
I have tried so many different settings to no avail.
Could anyone please provide some advise?
Please see picture attached.
Thanks very much guys
This has been very frustrating after so many hours, attempts and money wasted.
I have tried so many different settings to no avail.
Could anyone please provide some advise?
Please see picture attached.
Thanks very much guys