Hello!
I am trying to do a CLI configuration of the Modes tab based on the knowledge below.
Betaflight-4.0-CLI-commands-_Work-in-progress
I need to set the modes tab for a beginner droner.
a) switching modes

b) One engine emergency stop switch. About 10 cm above the ground for





 the copter to fall freely. I have the effect of the copter bouncing off the ground when I put the throttle down at the end of the flight. I'm learning to fly.
My current settings.

first of all, cli stands for commandline, the last tab in betaflight configurator.

disable airmode feature and toggle it by a switch for bouncefree landings - but even more easy use the armswitch 10cm befor the ground. the arm switch does stop your engines.

The term for the program is Betaflight Configurator and only one tab within it is called CLI.

In the MODES tab I have Arm/Disarm on a two way switch as AUX1 with arm state orange bar being last third of the bar right side (has to go that way for ELRS)

AUX2 is a three way switch and has two MODE lines, the first third from the left end being ANGLE orange active, the next third (middle) being HORIZON, and the last third does not need a status line and is ACRO.

I have Aux channels and Tx switches for Air Mode, Buzzer and Flip over after Crash.

I normally switch Air off and back to Angle to land.  All flight is usually ACRO.

This way all switches are back/up for base state, Disarmed, Angle, no Air mode, no crash flip.