OK i need the advise and help of the experienced builders out there..... still trying to understand INAV.... wanting to know is this setup possible... the betaflight F4 Fc only has 4 
PWM pads i see PWM 5 & 6 but how do they get power ?  this is going on a wing with steerable nose gear....  and retracts.. can i connect  SBUS, THR, L-ELEVON & R ELEVON and rudder (STEERING) to the FC ???? and connect the retract servo straight to the receiver ???? like the picture 

You can use an sBus to PWM decoder, it'll give you 4 pwm outputs

https://hobbyking.com/en_us/frsky-4-chan...tore=en_us

(27-May-2018, 04:27 AM)RENOV8R Wrote: You can use an sBus to PWM decoder, it'll give you 4 pwm outputs

https://hobbyking.com/en_us/frsky-4-chan...tore=en_us

so im taking thats a "NO" it wont work !    and on that board,  what is PWM 5&6 used for ? and how are they connected since its just a signal pad !!!!!  where do you get the power and ground from???  ( the 5v and gnd other side of the board)

RENOV8R   will this work as well.....https://www.youtube.com/watch?v=jUkutJrzXFI