Guys.. Sometimes I like solving the issues with my quads but this one has really really frustrated me and cost me a lot of money.

I have replaced every single part and still have the same issue. I'm not sure how that's even possible lol - I might just be overlooking something stupid and need a fresh brain to help me

I run individual ESCs. DYS Aria (blheli_32) escs. I have a brand new Matek PDB (xclass Fchub) I'm trying to install because I broke my last PDB.

Using a Tmotor F7 Pro FC. My ESC #2 is not being recognized. I swapped the ESC and it didn't make a difference. I swapped the motor, even though on BlHeli32, the esc#2 isn't even being recognized so I figured that wouldn't fix it. It didn't.

I tried switching the motor output to a fresh output on my FC. It didn't make a difference.

I bought a brand new FC and still have no response from ESC #2.

I switched all the wiring for the pinout between the PDB and FC as well as the wiring from the esc to the FC. The wiring is all new.

The motor pins m1-m4 from my PDB are direct soldered to the FC motor pads to ensure it's not an issue with the pinout/plug

I'm supposed to fly with the boys tomorrow and I still can't get this working. I'm so confused.

Please help!

That ESC is not found in BLHeli32, but is this as a set or when selected (bottom numbers) as the only one?

(19-Jun-2023, 06:44 AM)BadRaven Wrote: That ESC is not found in BLHeli32, but is this as a set or when selected (bottom numbers) as the only one?

Ah when I do 'read setup' it can find 1, 3, & 4 but it's not picking up #2 then on the ESC list after that it just shows ESC #2 - -