Flywoo GOKU GM10 Pro V3 installed in SpeedyBee F4 and it is not showing up in OSD. 
Blinking green light on GPS but no red light.  
No GPS data in OSD (not even zeroed out data) but other data (voltage, etc) shows up.  
I doubled checked the six wire were all going to the correct pads on the FC. 
I did load GPS when updating the SB firmware.
Everything else seems to work except the GPS.  

Suggestions to try Please!

Thanks in advance.

(13-Apr-2023, 08:03 PM)BobMaine Wrote: Flywoo GOKU GM10 Pro V3 installed in SpeedyBee F4 and it is not showing up in OSD. 
Blinking green light on GPS but no red light.  
No GPS data in OSD (not even zeroed out data) but other data (voltage, etc) shows up.  
I doubled checked the six wire were all going to the correct pads on the FC. 
I did load GPS when updating the SB firmware.
Everything else seems to work except the GPS.  

Suggestions to try Please!

Thanks in advance.

I am embarrassed to tell yall this but I had the wires (TX RX) backwards!  I went by this SB photo and the white wire should go where the yellow wire is and visa versa.  The COLORS are backwards.       I just went by the colors and didn't check the actual labels.   Stupid I am.   

lol if i had a dollar for every time ive messed that up even after double checking I'd be giving elon musk a run for his money.

at least it was a simple fix and now you can get flying