Posts: 1
Threads: 1
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2017
Reputation:
0 Hi just installed the Furious LR1000D on Diatone gt200 2017 with a taranis x9d plus, its binding fine but no switch inputs are showing active on the quad or in betaflight after its bound. Tried switching inversion off in cli no diffrence also is in D16 on tx. Please shed some more light if possible woukd really appreciate it will save me pulling out what little hair i got left..(saw your post Oscarliang.com)
Thanks
Regards
Ami
• Posts: 12,099
Threads: 125
Likes Received: 3,739 in 2,836 posts
Likes Given: 99
Joined: Feb 2017
Reputation:
388 10-Dec-2017, 04:46 AM (This post was last modified: 10-Dec-2017, 04:46 AM by voodoo614.) Are you getting stick inputs?
As far as switch, did you assign a switch to channel 5?
• Posts: 5,322
Threads: 674
Likes Received: 3,160 in 1,747 posts
Likes Given: 2,034
Joined: Jan 2016
Reputation:
139 You mentioned you have no switch input, but like Voodoo said, are you getting any stick inputs?
Let us know:
What FC you are using? F3 board should be fine, but on F4 board you need to use the dedicated SBUS port.
Which pin you are connecting the SBUS to?
Did you set up Serial RX on the correct UART in Ports tab in Betaflight?
Did you setup SBUS correctly in Configuration tab in Betaflight?
•