I have been flying my TH2 for a while but still a newbie to fpv I just bound it to my beta controller and had a hard crash 
Now when I plug the pack in I get 4 blue 4 green 1 red this repeats a 2nd time then the drone shuts off
Does any one have any good ideas

Unfortunately Emax FCs are not the greatest.. and they burn up pretty easy. Also they are expensive to replace, but there is a solution.. do a search for alternative tiny hawk flight controllers.. I did a full thread on adapter plates and so on ..
IF it is toast.. may I suggest NOT using the frame, beta fpv has one that it a little more “stout” unfortunately u will have to build it upside down due to the Emax props… I described it in the thread.. it’s also better as the motor bells/prop shell won’t hit the ground and break.(poor design)… the new fc is a little “exposed” but can easily be covered… I have been flying the crud out of mine.. I swear it handles better than the original TH..

(10-Oct-2021, 02:44 PM)Rob Axel Wrote: Unfortunately Emax FCs are not the greatest.. and they burn up pretty easy.  Also they are expensive to replace, but there is a solution.. do a search for alternative tiny hawk flight controllers.. I did a full thread on adapter plates and so on ..
  IF it is toast.. may I suggest NOT using the frame, beta fpv has one that it a little more “stout” unfortunately u will have to build it upside down due to the Emax props… I described it in the thread.. it’s also better as the motor bells/prop shell won’t hit the ground and break.(poor design)… the new fc is a little “exposed” but can easily be covered… I have been flying the crud out of mine.. I swear it handles better than the original TH..

Thank you Rob

This evening as I was flying this exact quad.. the beta frame will not accept a 450mh battery not a deal breaker.. but I would have sworn they would have fit.. I have been flying this in 300s