Broken capacitor on Fatshark screen logic board

[gizmoe101]

So I was trying to shorten the IPD on my dominator V3s and to make a long terrible story short I destroyed a ceramic capacitor on the underside of the screen logic board, the one that sits in-between the two screens, and I'm not sure what to do now. I could just replace it but I don't know what specs the capacitor had. Should I call fatshark and ask for a schematic? Could I just jumper the contacts? Should I take the board to a electronics repair center and have them put on a generic capacitor? 

Here are some Pictures.

[voodoo614]

You should contact Fatshark and ask what is the spec for that capacitor. I have had luck with other companies, they just simply tell me without giving out a full schematic. Doesn't hurt to ask.

Is the cap intact or completely destroyed?

[gizmoe101]

There is nothing left of the capacitor. And what pieces I did have shot off the table. I'll call Fatshark tomorrow and give an update. Thanks