Hey All!

So I had hoped this would be a good first quad for me... I think I was right in so far as I have already had to learn A LOT to get this far in my troubelshooting.  I have an inductix that seems to have a stuck throttle.  Meaning the Throttle gimbal on my TX works just fine.  I play around in Liftoff and all is well there.  I connect to Betaflight and I see all the axises and the aux channels moving as expected... EXCEPT... Throttle.  It just sits at 1017.

So here is what I know:

Blade Inductrix Pro BNF
Taranis X9D Plus
Orange TX box

I have flashed BetaFlight 3.2.5 (i think)
I have been able to pair the quad with the TX.  
I have a proper Arming switch configured.
In the Reciever Tab - Roll, Yaw, Pitch - All Respond as expected
THROTTLE - sits at 1017 and does not move regardless of stick position.
I CAN ARM - and when I do, the motors spin up to about what I would expect with them 1018 in the movement of the stick.

Channel Monitor on taranis shows the throttle moving, it just does not register in BetaFlight.
I played around and switch THR and ELE in Mixer - The Locked THR moved with the channel to the ELE axis and the ELE moved as I would exepct on what is normally the THR axis... so I know the TX is good and I am pretty sure setup is good.

what am I missing?  I almost feel like this a problem on the FC board, but I have no way to verify.

I sure would love to start flying this bad boy, bout the answer eludes me.

Thank you so much for any help you might be able to offer.

Cheers!
'D' 

Can you show photos of the channel input and mixer menu on radio? Can you also post receiver tabs photos?

Indeed I can... I THINK this is what you're asking for:

   
   
   



   

Does that help????

You need to subtrim throttle channel down to 1000. Once you do that, try to see if everything works.

If adjusting subtrim and the throttle is not moving, then can you post the input setup for the throttle channel?

Hiya Folks, thanks for the help... I think this is actually solved. It was a binding issue with the orange tx module, or at least a misunderstanding of the order of operations after the TX is bound to the Taranis.

Once they bind, turn off both devices, boot up Whoop first, then the taranis (making sure it is still in one blink mode. If its not in one bloink mode then triple tap until its one blinky and then reboot. Quad fires right up.

Now on to the next part of the advenutre... learning PID settings

If you're running betaflight (can you even do that on an Inductrix?) you should check out the Project Mockingbird tunings:
https://docs.google.com/document/d/11nzM...2FMWI/edit

They're supposed to make a betaflight whoop fly like an Inductrix which is still the standard.