Hi,
Yesterday I installed the BF 4.2 RC1 using bidirectional dshot.
I flashed my tekko32 4in1 with the 32.7.1 fw and the kakute f7 with a clean flash of 4.2rc1.
I verified the motors tab without battery and the error was 100% and with the lipo was 0%.

Below you can see some photo of the cli using command like status,tasks.....is it working or not?
I can't understand.....

Honestly sometimes with this RC1  I'm losing the GPS coordinate on osd and the crossfire rssi and LQ go up and down very fast(and in this case I think there is some bug...)

You want to look at the motors tab with the lipo plugged in (props off of course). Then crank up the motors one by one make sure you stay at 0% error.

(11-May-2020, 06:40 PM)the.ronin Wrote: You want to look at the motors tab with the lipo plugged in (props off of course).  Then crank up the motors one by one make sure you stay at 0% error.

Hi Ronin,yes all motor separately works with error 0 % with lipo on.

Ok cool sorry then I'm not sure why you think RPM Filtering is not working?

(11-May-2020, 11:19 PM)the.ronin Wrote: Ok cool sorry then I'm not sure why you think RPM Filtering is not working?

Because I was not sure that the 0% error was enough.


GrAzie

0% error is a perfect outcome. You should be good to go.