I'm not sure who would be running 6S on a toothpick, but here we have it

https://betafpv.com/products/toothpick-f...ablheli_32

BetaFPV Wrote:Only 30pcs boards are available now for the first batch. This board is only on website for beta test, save 10 bucks.

Why we would design this new board? Here is our consideration.

• There is no one with BLHeli_32 ESC integrated since the popular of these AIO Whoop or Toothpick board. This must be the first one.
  
• 5-6S battery power is available on this board. We have tested it on 6S battery and it works well. But, but pay atterntion to the over hit issue.
  
• 35A is our first attemption. We would like to design a 4inch fpv racing drone has the full performance.
  

But there are still something  we have not done on this first batch.

• Only one full UART is available (like the 20A V2 board) and not enough UARTs to support DJI FPV Unit and TBS CRSF receiver at the same time.
  
• Still STMF411 processor for the Betaflight firmware.
  

If you have the same thought as us, welcome to the be the beta test of this new board. The recommend frame is TWIG MUTANT or ET5.

 

there is a 6s „toothpick“ pnp version from hglrc, a buddy swor about it. he is a throttle-agressive pilot and get still 5min flighttime out of 300mah 6s. battery options are rare, he craft the lipos by himself to get a good mah size.

i beleive this board is for betafpvs next pnp, they bring a 5inch 6s under 250g to the market, or they should ;-)

Interesting!

In a year or so I think we will only have AIO boards in 20x20 or 26x26. Stacks will disappear and also 30x30 as they get smaller and smaller