Hi all,

I just got my Flywoo Explorer LR up and running. I installed my ExpressLRS EP1 rx and all seem to be working. 

Except! that when I arm, the quad start to continuously beep at about once per second. I also see the visual beeper on the OSD.  My battery is good and if I plug in Betaflight, it detects it as a proper 3S and proper voltage. 

I do see that the Link quality icon is blinking in the OSD.. would that behave this way? I'm not sure why that isn't working right, I might need to dig into ExpressLRS stuff. I did discover all the new telemetry sensors in my radio model. 

I just remember this has bluetooth. Maybe I'll mess with the phone app and toggle all the buzzer alarms on and off in real time. Right now they're pretty much all on.

In short, is there a way for it to display what the alarm is on the OSD?

If you are getting asterisks in the OSD then it sounds like the beeper is enabled. Make sure you switch on your transmitter and check that the switch you assigned to the beeper mode is in the beeper OFF position.

(27-May-2021, 08:55 PM)SnowLeopardFPV Wrote: If you are getting asterisks in the OSD then it sounds like the beeper is enabled. Make sure you switch on your transmitter and check that the switch you assigned to the beeper mode is in the beeper OFF position.

Ha, good call! I just checked the modes and hidden down below was the beeper set to AUX1. It came that way?!?! Thanks!