Dear  Friends,

This is my first post so please accept my apology if it is too long or too short.  I have the above FC which I installed with the DJI FPV system.  The DJI transmitter and goggles bind OK but I cannot get any stick movement or OSD information.  The FC box states DJI HD Ports RX and TX are on UART 3 and RX on UART 1 which I assume gives OSD info. I have switched on / off the UARTs one by one and still no stick movement or OSD.  I have tried earlier version of BF and of the FC firmware but still no joy.  Can anyone advise me what my next move should be.

Best Regards

Jon

Can you please run both the "dump" and "diff all" commands in the Betaflight Configurator CLI tab and copy/paste the results back here.

Please also post some good clear photos of the actual wiring and connections between the DJI Air Unit / Caddx Vista and the flight controller.

I found that the flight controller was faulty in the end

Thanks for your interest,

OK, no problem. Thanks for reporting back with the cause of the issue.

(27-Mar-2021, 11:54 AM)SnowLeopardFPV Wrote: Can you please run both the "dump" and "diff all" commands in the Betaflight Configurator CLI tab and copy/paste the results back here.

Please also post some good clear photos of the actual wiring and connections between the DJI Air Unit / Caddx Vista and the flight controller.