28-Apr-2024, 09:44 PM
The hardly comprehensive HDZero VTXManual states:-
Blue LED works as the following way:
(1) Flashing at 1HZ periodically if VTX heat protect.
(2) Flashing at 2HZ periodically if VTX is on pit mode.
(3) Flashing at 4HZ periodically if VTX is on 0mW.
(4) Flashing 4 times if MSP connection is established with FC after VTX
is powered up.
(5) Going off if the camera is not detected.
If a camera is attached, and get NO blue LED, please:
(a) Check if MIPI cable is secured on both end of camera and VTX, and
check if cable itself is fine.
(b) Carefully check VTX MIPI connector if there is any bent pin.
(c) If it is Foxeer Digisight camera, make sure it is NOT on analog
mode.
- Digisight goes to analog when pressing left for 3 sec.
- Use stick commands blindly or disconnect mipi and use external.
joystick.
- Joystick does not work in digital mode. Must use stick commands
(Thr mid, yaw right) to enter cam menu (BF OSD disappears).
But there are other undocumented codes. For example, two Blue Flashes, Pause, repeat. These appear not to be properly documented BY HDZero to public.
And that is apart from the fairly unclear descriptions given.
Is there any clear proven correct list of fault codes???
Blue LED works as the following way:
(1) Flashing at 1HZ periodically if VTX heat protect.
(2) Flashing at 2HZ periodically if VTX is on pit mode.
(3) Flashing at 4HZ periodically if VTX is on 0mW.
(4) Flashing 4 times if MSP connection is established with FC after VTX
is powered up.
(5) Going off if the camera is not detected.
If a camera is attached, and get NO blue LED, please:
(a) Check if MIPI cable is secured on both end of camera and VTX, and
check if cable itself is fine.
(b) Carefully check VTX MIPI connector if there is any bent pin.
(c) If it is Foxeer Digisight camera, make sure it is NOT on analog
mode.
- Digisight goes to analog when pressing left for 3 sec.
- Use stick commands blindly or disconnect mipi and use external.
joystick.
- Joystick does not work in digital mode. Must use stick commands
(Thr mid, yaw right) to enter cam menu (BF OSD disappears).
But there are other undocumented codes. For example, two Blue Flashes, Pause, repeat. These appear not to be properly documented BY HDZero to public.
And that is apart from the fairly unclear descriptions given.
Is there any clear proven correct list of fault codes???