you've all seen the tiny whoop by now here's my effort
link to my cam/vtx combo

http://www.surveilzone.com/16CH-25mW-000...ee--g-1304



firstly I wasn't happy with the plastic wiring from the cam, so swapped it out for some nice flexi silicon cable, splitting the cam was easy enough


added the 5v step up polulu, really small and does the job, this was stuck to the side of the cam with liquid electrical tape, didn't have any heat shrink big enough to contain it to the cam body, but that would have been first my choice


soldered to the board and stuck in place with some double sided foam tape


next was the chaoli motors from BG, pretty sure MMW used to call their motors chaoli ? this was about a ten minute job, ( pushing the motors from the bottom wth both my thumbs and holding the inner top part of the motor mount wth my fingers ) not sure why folks struggle with this, my buddy took ages, but I found it easy enough, wires are a bit longer than stock



I'd say they are very similar to stock to fly, maybe a bit quicker ?

with the stock battey my flight time is between 3 and 4 minutes, and i have just 2
but that really doesn't matter :d most fun I've had with the goggles on

do the Chaoli motors actually perform better than stock ones?

they feel a little faster but not by much tbh

nice job, and a Whooop achievment badge right there I reckon

That's a sharp lookin' Whoop! I like the swept-back antenna, and that you kept part of the canopy. Makes it look really fast....even just sitting there! Good job!

Cheers Scotty, I wanted to try and retain the looks of the inductrix ☺seems there are no Orange modules readily available, I've ordered some bits to make my own dsmx module, so I can fly it with the taranis, will post up some pics when I have all the bits in hand