If you enjoy our forum, why not join us? :) Login removes all the ads too! Click here to register in a few simple steps

Login to remove this ad | Register Here
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
U.fl to SMA
#1
I had to replace the pigtail on my TBS Unify Pro HV.  I can't get the new one to stay.  That U.fl connection is so weak.  I tried a dab of hot glue of the top of it but the Unify gets hot enough to melt hot glue; at least it did while it was sitting still.  Any tips to get this tiny connector to stay in place?


Thanks!
Quads:  RealACC X6R ; RealACC X210 Pro, Omnifbus F3 FCs; RunCam Swift 2 & Swift 2 Rotor Riot, Emax OG Red Bottoms, Emax RS2205S 2300kv; Fatshark DOM V3 YouTube - Mr.E_fPv
#2
Have you tried Bondic. Light cure, water resistant, heat resistant. I love this stuff.

https://www.amazon.com/dp/B00QU5M4MG/ref...3zbP405FNN

Since u. FL uses undercuts for retention, you can push in the leaves on the connector to get a tighter fit. But Bondic will help.
Reply
#3
Nice, I've never heard of Bondic. Looks interesting.
Quads:  RealACC X6R ; RealACC X210 Pro, Omnifbus F3 FCs; RunCam Swift 2 & Swift 2 Rotor Riot, Emax OG Red Bottoms, Emax RS2205S 2300kv; Fatshark DOM V3 YouTube - Mr.E_fPv
Reply
Login to remove this ad | Register Here
#4
Much cleaner than hot glue. Great for port connectors and wire after soldering.
[-] The following 1 user Likes voodoo614's post:
  • rryyyaann
Reply
#5
Shrink tube and black silicone is what was recommended by TBS support. I put the shrink tube on and that holds in in place very nicely.
Quads:  RealACC X6R ; RealACC X210 Pro, Omnifbus F3 FCs; RunCam Swift 2 & Swift 2 Rotor Riot, Emax OG Red Bottoms, Emax RS2205S 2300kv; Fatshark DOM V3 YouTube - Mr.E_fPv
Reply