(26-Jan-2020, 11:41 PM)voodoo614 Wrote: Not necessarily.

Too late. I already did the fresh FW and RPm filtering and all set up and ready now. I just hate that it's winter here and everythings buried in snow. I have access to a gym at one of the Jr Highs but only on Saturday and I'm tied up till the week after next. I think I'll get some silicone conformal after all. Been holding off cause it's not cheap in Canada. 40 bucks for 2floz. (55ml). I just checked the price again and it's on sale for $17. I have to hurry and snatch some up quick hahaha    KK Thx everyone. You've all been great.

(26-Jan-2020, 11:44 PM)ProppedCodger Wrote: I always check "Erase" when upgrading firmware personally just to be safe, especially since 4.0 with so many changes happening.   I write-down my rates and filter settings on paper quickly beforehand, the rest can be banged-off manually in a few minutes from memory.

Yes same here. Always a full chip erase. I was asking if I should do a fresh FW flash for RPM filtering, even though I'm already on 4.1

Oh sorry I misunderstood. I just flashed my ESCs and went into my current BF 4.1 to change DShot and filter settings, etc.

did you ever get your jazzmaverick to work?
Also which firmware do you guys use for BetaFlight/tyro79
matek f411 (there are several versions)
or
betaflight_4.1.4_STM32F411.hex

jazzmaverick is still „experimental“, but it works great.
4.1 is needed for rpmfilter, it doesnt matter which version. 4.1.4 should be the latest version.

(01-Mar-2020, 10:33 PM)mrelder Wrote: did you ever get your jazzmaverick to work?
Also which firmware do you guys use for BetaFlight/tyro79
matek f411 (there are several versions)
or
betaflight_4.1.4_STM32F411.hex

Use the latest Betaflight configurator and Matek "MTKS" firmware. And yes the JazzMaverick esc firmware is working fine on my Tyro79