Same old project. I've put a 470 ohm pull up resistor in the circuit and it doesn't bind. Would it had been better if I'd used a 1kohm resistor instead? (As per Thomas at Man Unmanned) - Someone must have the electronics knowledge to answer this, I certainly haven't!
I've got my Elrs Rx wired to the TinyGo, lots of lights come on but the Rx has a constant light, so apparently is stuck in bootloader mode and won't bind to a Jumper T-lite
Edit. I've tried everything but I always get the solid blue light.
One of the two boards must be faulty - I expect I nadgered the FC whilst soldering. I tried different resistors and checked everything with my multimeter too. Oh well, it wasn't new!?.
Thanks to everyone one who made suggestions anyway.
I see Geprc have a new AIO FC since Christmas and I'm thinking I might try it. However I'll start a new thread for that episode. I do like the TinyGo - just not its G8 transmitter!
I've got my Elrs Rx wired to the TinyGo, lots of lights come on but the Rx has a constant light, so apparently is stuck in bootloader mode and won't bind to a Jumper T-lite
Edit. I've tried everything but I always get the solid blue light.
One of the two boards must be faulty - I expect I nadgered the FC whilst soldering. I tried different resistors and checked everything with my multimeter too. Oh well, it wasn't new!?.
Thanks to everyone one who made suggestions anyway.
I see Geprc have a new AIO FC since Christmas and I'm thinking I might try it. However I'll start a new thread for that episode. I do like the TinyGo - just not its G8 transmitter!