BETAFPV F405 12A V3 BLHeli_S 2-4S AIO Whoop Flight Controller i installed in a 75mm frame and now it shows upside down in beta flight and i did not install it upside down.

It looks like the motor plugs face down with the receiver plug on top.  It doesn't really matter though even if it is mounted upside down, you can correct that in Betaflight.

You would need to change the Board and Sensor Alignment in BetaFlight 180 degrees on ROLL axis.

Then click save at bottom.





EDIT: Forgot to say if yours already shows 180 there, then that is why it is showing upside down. In that case just put it to 0, and click save.

(24-Oct-2021, 09:34 PM)MrSolo Wrote: It looks like the motor plugs face down with the receiver plug on top.  It doesn't really matter though even if it is mounted upside down, you can correct that in Betaflight.

You would need to change the Board and Sensor Alignment in BetaFlight 180 degrees on ROLL axis.

Then click save at bottom.





EDIT: Forgot to say if yours already shows 180 there, then that is why it is showing upside down. In that case just put it to 0, and click save.

OK thanks it was at 0 then i changed it to 180 degrees and 180 degrees corrected the issue like you stated.