Hello.i noticed that on betaflight my spektrum range goes only from 1140 to 1845 and the correct values on bflight are 1000 to 2000.
To reach 1050-1950 i had to set all the ch EPA to their max of 125% and then the rcrange function on Cli to get 999-2000.
Now it works fine (I can arm now) but i can not use trims because the end points are at the Max..
Is this procedure correct??
tia

Which transmitter? On some you can additionally stretch dual-rates beyond 100%, but adjusting rx range works just as well.

But i would adjust subtrim (center) first.

Just a dx6i...Setting end points to max both low and high the center value stays @ 1499 without sub trims. ...
On betaflight wiki they suggest to adjust tx before using rcrange command in cli.
No problems that my epa are at max???

I'm not sure anymore what the dx6i can do and what not, i'll check later at home... But servo travel endpoints at max isn't a problem by itself i'd say.

You could adjust rx range say 2-3 points lower so you have a bit of reserve if you need to trim?

Thanks. Do you mean lowering epa on tx or on rcrange cli?

I mean in CLI. So you can still reach 1000-2000 even if you have to trim towards one side or the other.

Great! Thx