Emax is releasing a F3 flight controller with built-in OSD - the Skyline32+OSD F3. Excited to see how it performs in my 3" build !
Good
Not so good
Good
- Good for tight builds with limited space
- Solder pads for direct soldering to the VTX and FPV camera
- The OSD allows you to tune your multirotor on the field using OSD menu and radio transmitter sticks
- No need to worry about OSD wiring and setting up
- Flash memory chip
- It has 8 PWM pins (motor outputs) and supports Tricopter, Quadcopter, Hexacopter and Octocopter config
- I like the fact that for UART you have the choice of using either header pin holes or JST connectors. (UART 1)
- It allows you to connect your OSD + SmartPort + SBus + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors – all at the same time!
Not so good
- Confusing pinouts
- Full of JST connectors
- Using MPU6050 but with I2C