Posts: 6
Threads: 1
Likes Received: 2 in 2 posts
Likes Given: 1
Joined: Apr 2017
Reputation:
0 Hi Everyone,
I have a very interesting issue which I can't solve.
In my quad I have a Skyline 32 Advanced version 1.1 flight controller with cleanflight and a micro minim osd. Set it up everything and the OSD works fine picking up all the data. But the issue is from my radio not picking up the inputs except the AUX which I can see it works on my OSD. No throttle, yaw, pitch or roll. When I add a battery when in Cleanflight it says loading but nothing happens. Now I lost :-\
Any idea?
• Posts: 2,286
Threads: 38
Likes Received: 1,527 in 995 posts
Likes Given: 1,881
Joined: Apr 2016
Reputation:
72 Sounds like you have the wrong channel ordering set in Cleanflight.
• Posts: 6
Threads: 1
Likes Received: 2 in 2 posts
Likes Given: 1
Joined: Apr 2017
Reputation:
0 Thanks I checked it already.
So I unpluged the osd from the RT Port on flught board then everything works. When I plugged back the osd to RT and connecting only the USB to board my receiver lights up too. When add the battery only the last 4 channel works on receiver.
• Posts: 2,286
Threads: 38
Likes Received: 1,527 in 995 posts
Likes Given: 1,881
Joined: Apr 2016
Reputation:
72 Can you show us how you are connecting everything? I don't know what the "RT" port is.
Also, what receiver are you using?
• Posts: 2,286
Threads: 38
Likes Received: 1,527 in 995 posts
Likes Given: 1,881
Joined: Apr 2016
Reputation:
72 OK, that's a good start.
Where is the receiver connected?
• Posts: 6
Threads: 1
Likes Received: 2 in 2 posts
Likes Given: 1
Joined: Apr 2017
Reputation:
0 Connected to the RC_IN. If I unplug the osd from the RT then all 8ch works fine. If plug it back the first 4 channel is gone.
• Posts: 2,286
Threads: 38
Likes Received: 1,527 in 995 posts
Likes Given: 1,881
Joined: Apr 2016
Reputation:
72 Also, about that "RT" connector.
The connector is wired to UART1 and that UART is also connected to the CP2102 chip that goes to the USB socket. So, if you just connect USB and no power, you will be able to connect via the configurator. If you plug in your battery, the OSD will get power and you can no longer connect via USB unless you disconnect the OSD.
•