Hi guys,
I'm new here and I finally finished my first racing drone build. Everything works fine, except for the following software problem:
I can see all correct transmitter values in betaflight. When I switch to ARM mode all motors start to rotate, but I don't get any changing values when I move the sticks anymore. The motors are spinning constantly and the other switch returns changing values when I move it. Is that normal in ARM mode?
To take off I have to switch to ARM mode, so the motors start to spin constantly. Then I have to increase the throttle a little bit and switch ARM back to zero. And only after switching ARM back the motors are spinning faster and I can control the quad with the sticks.
Arming only with sticks is not possible.
I have recorded a video of it to make it clear:
Thank you for your help!
I'm new here and I finally finished my first racing drone build. Everything works fine, except for the following software problem:
I can see all correct transmitter values in betaflight. When I switch to ARM mode all motors start to rotate, but I don't get any changing values when I move the sticks anymore. The motors are spinning constantly and the other switch returns changing values when I move it. Is that normal in ARM mode?
To take off I have to switch to ARM mode, so the motors start to spin constantly. Then I have to increase the throttle a little bit and switch ARM back to zero. And only after switching ARM back the motors are spinning faster and I can control the quad with the sticks.
Arming only with sticks is not possible.
I have recorded a video of it to make it clear:
Thank you for your help!