20-Apr-2017, 07:41 PM
Receiver: FrSky x4r
Flight Controller: Naze32 Rev6
******
First off, Oscar - I know you don't use this flight controller, but I'm hoping someone has an answer for me.
As a precursor to this post, please note that I have read the following articles:
https://oscarliang.com/sbus-smartport-telemetry-naze32/
https://oscarliang.com/ppm-sbus-d4r-ii-x4r-sb/
I have also skimmed through this forum, and Google searched for the answer to this question. It may boil down to just giving it a try, but I wanted to put it to the community first.
Question: I am using PPM on my x4r, and had to use the jumper to short two pins in order to bind it to my Taranis. Now, I want to be able to PID tune with my Taranis, and need to set up Smart Port Tx/Rx in order for that info to be sent/received between my FC and Taranis. Can I just use the soft serial with only the Smart Port line connected to the shorted RC5/RC6 pinholes on my Naze32 rev6 - whilst keeping the rest PPM? Or do I need to rebind the receiver in an SBUS setup?
I have attached a pic of my receiver connected in PPM format, and am hoping that someone has insight on this. Worse case scenario - I'll just hook up the SmartPort and give it a try... and keep my fingers crossed
Thanks in advance for any help y'all can provide.
- Mateo
Flight Controller: Naze32 Rev6
******
First off, Oscar - I know you don't use this flight controller, but I'm hoping someone has an answer for me.
As a precursor to this post, please note that I have read the following articles:
https://oscarliang.com/sbus-smartport-telemetry-naze32/
https://oscarliang.com/ppm-sbus-d4r-ii-x4r-sb/
I have also skimmed through this forum, and Google searched for the answer to this question. It may boil down to just giving it a try, but I wanted to put it to the community first.
Question: I am using PPM on my x4r, and had to use the jumper to short two pins in order to bind it to my Taranis. Now, I want to be able to PID tune with my Taranis, and need to set up Smart Port Tx/Rx in order for that info to be sent/received between my FC and Taranis. Can I just use the soft serial with only the Smart Port line connected to the shorted RC5/RC6 pinholes on my Naze32 rev6 - whilst keeping the rest PPM? Or do I need to rebind the receiver in an SBUS setup?
I have attached a pic of my receiver connected in PPM format, and am hoping that someone has insight on this. Worse case scenario - I'll just hook up the SmartPort and give it a try... and keep my fingers crossed
Thanks in advance for any help y'all can provide.
- Mateo