15-Jul-2016, 06:52 PM (This post was last modified: 15-Jul-2016, 06:53 PM by JimmyLe813.)
i recently built a TC-R220 to see how I would like flying a frame for 5" props. after destroying the TC-R after about 2 weeks of hard crashes and mid air collisions I decided to go with an authentic QAV-R this time. plus it made it easier cause all I had to do was move everything from one frame to another. here's what I'm using.
SP Racing F3 Acro board
DYS SE2205-2300kv motors
LB 30A esc
X4R-SB rx
RCTimer FT958 vtx
RunCam FPV board camera
RK 5045 Tri-blades
as you can see from the pics I depinned everything and soldered all my connections from the bottom of flight controller to make it look as clean as I can. well time to go cross my fingers and maiden and tune. I will try to post some flight video later.
SP Racing F3 Acro board
DYS SE2205-2300kv motors
LB 30A esc
X4R-SB rx
RCTimer FT958 vtx
RunCam FPV board camera
RK 5045 Tri-blades
as you can see from the pics I depinned everything and soldered all my connections from the bottom of flight controller to make it look as clean as I can. well time to go cross my fingers and maiden and tune. I will try to post some flight video later.