Hello guest, if you read this it means you are not registered. Click here to register in a few simple steps, you will enjoy all features of our Forum.
This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Multishot help
#1
After selecting Multishot in Betaflight, i can no longer arm the quad, FC LED just flashes slowly.
I am using Naze32 R5, cicada Blheli_s 20A esc (multishot supported)

Do I need to enable multishot in BLHeliSuite? I thought protocol is detected automatically?
Reply
Login to remove this ad | Register Here
#2
I think you need at least 2K looptime to run multishot:
http://intofpv.com/t-enable-multishot-in-betaflight

and make sure your CPU load isn't too high (should be below 30% when idlee on the desk)

Try to disable ACC and other unneeded features.

If still no luck, try to move back to oneshot?
Reply
#3
Thanks!
Turns out the naze rev5 is overloading on 2k/2k so i had to lower it
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Multishot on Racerstar ESCs? bombarie 3 2,970 28-Sep-2016, 08:13 PM
Last Post: bombarie
  Aikon SEFM 30A and multishot mockyrc70 0 1,014 12-Sep-2016, 02:16 PM
Last Post: mockyrc70
  Help Flash Multishot to SN20A BL20A ESC? OverDischarged 1 2,691 02-Jul-2016, 01:51 AM
Last Post: SkinnyShark


Login to remove this ad | Register Here