18-Dec-2016, 02:47 AM
Greetings all….have had a bit of a brain fart here. I am nearing completion on my current build and I am having a bit of a problem calibrating the ESC’s……for that matter even recognizing them. Set up is as follows:
FC: X-Racer v3.1
ESC’s: Flycolor Raptor BLS series 30A
Motors: Emax 2205 2300kv
FC has the following firmware loaded: BetaFlight/X_RACERSPI 3.0.1 Oct 18 2016 / 10:40:35 (48b7b4f)
I am using BLHeli Suite 16.514.8.0.0
Problem……motors will not spool up. Trying to access them through Betaflight they just act like they aren’t there. I think pass though is working, but when I try and use BLHeli to read or check the current version on the ESC’s I get the following error:
The motors remain completely still and silent until I turn the transmitter on. As long as it’s on, Motor number four will twitch and slowly revolve. Doesn’t matter if it’s armed or not. I suspect I am doing something really stupid and if someone could point that out to me I would be grateful. Thanks Guys!!
FC: X-Racer v3.1
ESC’s: Flycolor Raptor BLS series 30A
Motors: Emax 2205 2300kv
FC has the following firmware loaded: BetaFlight/X_RACERSPI 3.0.1 Oct 18 2016 / 10:40:35 (48b7b4f)
I am using BLHeli Suite 16.514.8.0.0
Problem……motors will not spool up. Trying to access them through Betaflight they just act like they aren’t there. I think pass though is working, but when I try and use BLHeli to read or check the current version on the ESC’s I get the following error:
The motors remain completely still and silent until I turn the transmitter on. As long as it’s on, Motor number four will twitch and slowly revolve. Doesn’t matter if it’s armed or not. I suspect I am doing something really stupid and if someone could point that out to me I would be grateful. Thanks Guys!!
"Damn the torpedoes!!! Full speed ahead!!!"