Posts: 1,490
Threads: 92
Likes Received: 574 in 468 posts
Likes Given: 0
Joined: Nov 2020
Reputation:
27 When I arm, all motors start spinning.
Then motor4 sputters, and stops entirely.
Will not spin again until unplug, replug battery.
No BLHeli error shutoff beep.
What could be causing this!?
Anybody ever have anything like this?
• Posts: 4,550
Threads: 38
Likes Received: 1,245 in 1,064 posts
Likes Given: 430
Joined: Aug 2020
Reputation:
118 I doubt this is a firmware issue but more hardware specific.
• Posts: 1,490
Threads: 92
Likes Received: 574 in 468 posts
Likes Given: 0
Joined: Nov 2020
Reputation:
27 This is the GHF411 that somehow suddenly MCU died.
I flew quad many many months. Pull it off the wall.. no BLHeli chime response. After tons of troubleshooting, swapped working F411 from Flywoo board.
Now this.
Maybe hot air shifted something.
• Posts: 4,550
Threads: 38
Likes Received: 1,245 in 1,064 posts
Likes Given: 430
Joined: Aug 2020
Reputation:
118 Hot air can be tough to focus the heat at the component you are removing or reworking especially on board sizes used in FPV.
Its not uncommon to unintentionally move other components.
•