If you enjoy our forum, why not join us? :) Login removes all the ads too! Click here to register in a few simple steps

Login to remove this ad | Register Here
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor 2 and 4 not spinning on KISS FC build
#1
Hi All,

I have a DIY quad build with KISS FC.  I have the KISS firmware upgraded and in the data output my transmitter is transmitting correctly.  However motor 2 and 4 will not spin and they beep constantly when trying to do a motor test.  I have been through the ESC calibration protocol several times to no avail.  My ESC mode is set to PWM.  Motors 1 and 3 (top board) spin up fine on the test, but motor  2 and 4 from the bottom do not spin up only beep ...beep beep
#2
What type of escs?
Reply
#3
They came with the YoCoo f450 DIY drone.

Three blue wires going from the ESC to motor and then the red/black power and the red/white/black ESC wires

They are wrapped in yellow shrink
Reply
Login to remove this ad | Register Here
#4
You could try moving your throttle trim down a bit before you arm it. I haven't heard of it beeping the motors from this though, usually it just won't spin.
Reply
#5
Did you go through esc calibration step by step following the manual?

http://kiss.flyduino.net/dwkb/calibratin...h-the-gui/

I calibrated them once and forgot to plug in the lipo. Maybe thats the issue?
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
Information Recommendation for a Cheap Mini Quad Build for Beginners Oscar 29 3,484 11-Jul-2017, 04:40 PM
Last Post: Carl.Vegas
Exclamation Choosing suitable motors for first 250 build!!! Phong 16 296 11-Jul-2017, 12:49 AM
Last Post: Phong
  Tutorial: How to check if motor screws are touching winding Oscar 5 173 17-Jun-2017, 12:19 PM
Last Post: Tom BD Bad
  Solved brushed Hollow Cup Motor pips 2 151 03-Jun-2017, 07:25 PM
Last Post: pips
Thumbs Up RESOLVED: New build F450 - APM2.8 flabombarda 0 111 26-May-2017, 03:31 AM
Last Post: flabombarda