Hello guest, if you read this it means you are not registered. Click here to register in a few simple steps, you will enjoy all features of our Forum.
This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor 2 and 4 not spinning on KISS FC build
#1
Hi All,

I have a DIY quad build with KISS FC.  I have the KISS firmware upgraded and in the data output my transmitter is transmitting correctly.  However motor 2 and 4 will not spin and they beep constantly when trying to do a motor test.  I have been through the ESC calibration protocol several times to no avail.  My ESC mode is set to PWM.  Motors 1 and 3 (top board) spin up fine on the test, but motor  2 and 4 from the bottom do not spin up only beep ...beep beep
Reply
Login to remove this ad | Register Here
#2
What type of escs?
Reply
#3
They came with the YoCoo f450 DIY drone.

Three blue wires going from the ESC to motor and then the red/black power and the red/white/black ESC wires

They are wrapped in yellow shrink
Reply
#4
You could try moving your throttle trim down a bit before you arm it. I haven't heard of it beeping the motors from this though, usually it just won't spin.
Reply
#5
Did you go through esc calibration step by step following the manual?

http://kiss.flyduino.net/dwkb/calibratin...h-the-gui/

I calibrated them once and forgot to plug in the lipo. Maybe thats the issue?
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  First Build - prevent antenna chop? JohnnyCornRocket 5 129 Yesterday, 02:16 PM
Last Post: iFly4rotors
  4 inch frame with 16x16 motor mounting holes Pathfinder075 10 170 19-Mar-2024, 07:02 PM
Last Post: Pathfinder075
  Best Battery Option for Build - Begginer Arkadius27 7 151 19-Mar-2024, 04:40 PM
Last Post: Pathfinder075
Sad What to check for short in a build? Yesnok 1 108 03-Mar-2024, 12:06 PM
Last Post: iFly4rotors
  First Build Critique Crashesintotrees 3 165 01-Mar-2024, 04:25 PM
Last Post: Pathfinder075


Login to remove this ad | Register Here