As i mentioned in the speed addict thread i have made a BIG mistake and wired the ground signal wire to the TLM on my 24a esca and now they are lifeless. does anyone know of a fix for this or are they just toast now?
 waiting in anticipation

I wouldn't have thought soldering the gnd signal wire to the TLM would have caused your ESC's to die. If it was going to be an issue one would have thought KISS would have made a note in the ESC manual.

Maybe a KISS expert can help here.

(02-Jul-2016, 11:39 AM)BigglesFPV Wrote: I wouldn't have thought soldering the gnd signal wire to the TLM would have caused your ESC's to die.  If it was going to be an issue one would have thought KISS would have made a note in the ESC manual.

Maybe a KISS expert can help here.

Yes with a little luck.
there was no smoke or fire just the blue light went out and went lifeless. Ive looked in the manual and forums and cant find anything regarding this problem yet it was such an easy thing to do. As with all other escs the solder pads are together but there again they dont have the telemetry capabilitys of these. That ground pad is soooo small tho and being nearly 50 my eyes arent getting any better

I dont think anyone would be technical enough to answer this question apart from the guys at Flyduino, drop them a message and find out
But the TLM is a output, shorting it to GND will probably cause some large current and burning something...

(02-Jul-2016, 12:46 PM)Oscar Wrote: I dont think anyone would be technical enough to answer this question apart from the guys at Flyduino, drop them a message and find out
But the TLM is a output, shorting it to GND will probably cause some large current and burning something...

Thanks oscar.
I have mailed them about it but yet to receive an answer. 
  I didnt see smoke or fire and ive had a watchmakers glasses on taking a very close look and there is no burn marks, anything melted or any visible damage at all.
 This could be an expensive mistake eh.