03-Dec-2017, 08:15 PM
newbie to FPV.
I have a KINGKONG/LDARC TINY7 75mm Micro FPV Quadcopter With 720 Brushed Motors Baced on F3 Brush Flight Controller. recently one my motors died. just to be sure it was the motor I swapped it with one of the other motors and it worked "bad motor". ok. so I ordered a new motors from Ebay "2PCS Kingkong 720 Brushed Motor Brush CW CCW for Tiny7 Racing Quadcopter " same color wires, same connectors made it very easy to replace. this comes with beta flight 3.0.1. I replaced the bad motor and now there's no lift. I thought this was a simple replacement did I miss something? also I did order two sets of motors so yes I did swap new motors also just in case. I can't find any info on this problem. is it possible there is a calibration I need to do in beta flight?
I have a KINGKONG/LDARC TINY7 75mm Micro FPV Quadcopter With 720 Brushed Motors Baced on F3 Brush Flight Controller. recently one my motors died. just to be sure it was the motor I swapped it with one of the other motors and it worked "bad motor". ok. so I ordered a new motors from Ebay "2PCS Kingkong 720 Brushed Motor Brush CW CCW for Tiny7 Racing Quadcopter " same color wires, same connectors made it very easy to replace. this comes with beta flight 3.0.1. I replaced the bad motor and now there's no lift. I thought this was a simple replacement did I miss something? also I did order two sets of motors so yes I did swap new motors also just in case. I can't find any info on this problem. is it possible there is a calibration I need to do in beta flight?