Hi Team,

I am using EMAX 2205 motors and using Kingkong 5045 (2 blade) propellers. While installing the propellers, they fit very tightly (after fitting motor screws) and very difficult to remove them.

What are better ways to install and uninstall propellers?

Thanks,
Srinivas

Motor pliers like these are very helpful.
https://www.amazon.com/Usmile-Quadcopter...B07795HBCL

I use a 1/4" ratchet with a socket. I can usually remove them by just gripping the prop with my hand and loosening with the ratchet. Once I loosen the nut it comes off easy just holding the bell with my fingers Sometimes I use a rag because some props are sharp and I always use one when putting them on since I want the nut tight but don't want my fingers to bleed.

(25-Aug-2018, 01:23 PM)RENOV8R Wrote: Motor pliers like these are very helpful.
https://www.amazon.com/Usmile-Quadcopter...B07795HBCL

Hi All,

thanks for inputs.

Thanks,
Srinivas

I use a length of rubber vacuum belt

Never forget to bring a rubber!