INAV Version - 7
Radio - Taranis x9 lite
Radio firmware version - 2.3.15-otx (1004ef7c)
Rx - frsky r-xsr (non access)
FC - matekf722se
wiring - fport to TX2
Ports tab,
Receiver tab,
Currently INAV is recognizing my radio movements in Receiver tab.
Note: I had this whole thing setup years back and was working too. But after a radio upgrade I think I lost all.
Radio - Taranis x9 lite
Radio firmware version - 2.3.15-otx (1004ef7c)
Rx - frsky r-xsr (non access)
FC - matekf722se
wiring - fport to TX2
Ports tab,
Receiver tab,
Currently INAV is recognizing my radio movements in Receiver tab.
- How do I know if my fport setup is correct and telemetry from FC is receiving at radio? I went to TELEMETRY page in radio and looked under Sensors, when I connect a battery to quad I can see VFAS shows correct battery voltage also Curr shows 1.5A (probably because VTX got turned on)
- How do I gets OpenTX-Telemetry-Widget (https://github.com/iNavFlight/OpenTX-Telemetry-Widget) installed on the radio?
Note: I had this whole thing setup years back and was working too. But after a radio upgrade I think I lost all.