18-Jun-2021, 10:11 AM
Hey all,
I have recently installed iNav 3.0 on my SpeedyBeeF4, and after sensor calibration tried to see if the motor spun up. It didnt, so I re-flashed Betaflight and it worked. Then re-flashed iNav and set a Quad profile, and the motor worked. Re-loaded a plane profile, and it didn't. I tried getting the motor to spin by flipping the 'i am sure' switch on the motors tab and moving the slider but no go.
I'm a bit puzzled by this. Anyone have a clue as to where to look?
TIA!
I have recently installed iNav 3.0 on my SpeedyBeeF4, and after sensor calibration tried to see if the motor spun up. It didnt, so I re-flashed Betaflight and it worked. Then re-flashed iNav and set a Quad profile, and the motor worked. Re-loaded a plane profile, and it didn't. I tried getting the motor to spin by flipping the 'i am sure' switch on the motors tab and moving the slider but no go.
I'm a bit puzzled by this. Anyone have a clue as to where to look?
TIA!