Hi! Please try to help me get this issue figured out! I have had a Wizard for a few months and haven't had a single issue except noisy bearings in the motors. Well I bought a set of Emax rs2205 2300kv motors and soldered them up same as old motors but 2 spun wrong direction so I changed 2 wires. It flew ok but seemed down on power but kept flying and I noticed 1 motor was a little warmer than others well 5 or 6 packs later it death rolled. I checked everything connections inside and out no problems but motor 3 is cogging, studdering, and stopping. I noticed a tiny cap was missing from esc {v2 20amp Racestar}so I changed esc but still exact issue then soldered old Wizard stock motor to 3rd esc and damn same thing and I know the motor is good and esc is new so FC maybe. I am still learning how to check and change pins but I wanted to see if anyone could help me out with this issue? I just got my son one for Christmas and now I am not flying. Sucks! Thanks for any help!

Did you calibrate the new ESC?

This happened to me. And it turned out to be the trim. Is all you stick trim centered?

Hey thanks for the replies! I figured out what it was the PDB one of the esc pads have failed somehow the trace separated. Sucks cause I just got my son a fpv setup now I am grounded for a few days! Thanks again for the replies!