23-Jun-2017, 08:47 AM
Hi can any one shy me light here please
I have received my Omnibus f4 Pro V2 yesterday.
Wired all turns on fine.
Checked board before wiring all worked fine Connected to Betaflight fine.
Then I come to Update firmware and board turn it self in DFU mode Did Erase then flash but its stuck on Flashing at full bar.
And don't do nothing
If I disconnect and reconnect I get no response from controller NOTHING COMES ON PC.
IF I press boot it turn in DFU mode but cant flash it it stuck on Flashing again.
Any one had this issue ???
Regards
I have received my Omnibus f4 Pro V2 yesterday.
Wired all turns on fine.
Checked board before wiring all worked fine Connected to Betaflight fine.
Then I come to Update firmware and board turn it self in DFU mode Did Erase then flash but its stuck on Flashing at full bar.
And don't do nothing
If I disconnect and reconnect I get no response from controller NOTHING COMES ON PC.
IF I press boot it turn in DFU mode but cant flash it it stuck on Flashing again.
Any one had this issue ???
Regards