09-Nov-2017, 12:24 PM (This post was last modified: 23-Nov-2017, 05:11 PM by kase04. Edit Reason: Solved )
Hi all,
I have a problem with my micro Build FLY EGG 100mm, maybe someone can help me....
I plug the battery into the ESC 4in1, everything is fine, the ESCs sound and the FC has power. I go to BF I set everything up and when I try the motors tab, each motor does the same, turns left then right and stops and emits a peeee. I'm desperate I switched from ESC to another of the same model but new, same result, I bought another King Kong 1103 7800kV engine pack, same result. I have flashed the ESC to different BLHeli verions, now I have the 16.6 Dshot. I've tried Dshot Multishot to Oneshot, each with its corresponding firmware. I have tried to change the firmware of the FC for others even from February 2017 without getting anything. Even I tested to remap motors with the resource command in CLI. I do not know what else to do.
Could someone help me, I am desperate with my micro, it is the first micro build I do, I have already mounted two drones in 250 and 210 and I have some experience.
My build is this:
Frame: King Kong Fly Egg 100
ESC: Eachine minucube 10A 4in1
FC: Eachine Minicube F4 v1.1
Power: 2s LIPO
I have not mounted the RX/VTX/CAM/OSD yet.
Thank you very much to all!
I have a problem with my micro Build FLY EGG 100mm, maybe someone can help me....
I plug the battery into the ESC 4in1, everything is fine, the ESCs sound and the FC has power. I go to BF I set everything up and when I try the motors tab, each motor does the same, turns left then right and stops and emits a peeee. I'm desperate I switched from ESC to another of the same model but new, same result, I bought another King Kong 1103 7800kV engine pack, same result. I have flashed the ESC to different BLHeli verions, now I have the 16.6 Dshot. I've tried Dshot Multishot to Oneshot, each with its corresponding firmware. I have tried to change the firmware of the FC for others even from February 2017 without getting anything. Even I tested to remap motors with the resource command in CLI. I do not know what else to do.
Could someone help me, I am desperate with my micro, it is the first micro build I do, I have already mounted two drones in 250 and 210 and I have some experience.
My build is this:
Frame: King Kong Fly Egg 100
ESC: Eachine minucube 10A 4in1
FC: Eachine Minicube F4 v1.1
Power: 2s LIPO
I have not mounted the RX/VTX/CAM/OSD yet.
Thank you very much to all!