Hey all,

I have been having issues with my FPV feed since the beginning. I thought I had fixed the issue because I realized I didn't match the polarization of my antennas correctly.

Turns out while that did clear up a lot of my static it didn't fix my overall problem. Today I was flying and then all of a sudden the screen went white with a faint image on it but it was just frozen. Cause me to out it into a tree. Image wouldn't change. Once I turned off the goggles and back on the video was fine.

Is there anything with the vtx or quad that could cause this behavior or is it most likely the goggles. I opened them up and one of the jst connectors wasn't seated right. One of the pins inside was a little bent and I think wasn't getting a good connection. Fixed that but didn't get a chance to test. Any thoughts?

Goggles are eachine vrd2 by the way.

The faint image you describe might just be "burned in" in the LCD screen when it went white... happens on my goggles when i let the quad look towards the sun for a while before i start, but the "ghost image" usually goes away after a few seconds.

Hm but the fact that it went white... let's just hope you already fixed it with that pin/connector, i wouldn't have an idea what else.

Yea I'm pretty sure it's the goggles. Will try tomorrow before work