I just got my Furious receiver yesterday and wondered why when I use the Band Scanner and than I select that channel I can't even see anything until I manually select another band?  The scanner clearly shows it the best channel by a huge amount?

Thanks,

Dennis

The Band Scanner tends to stop in the first channels it detects power... that means it could be some channels very close to the real one in terms of frequency , even if they are in completely different band. I found I just have to keep scrolling to the next one if it's not the one.

I only have to use band scanner when i want to watch my friend flies, I save all of my own channels. The "working channel" feature is great as it saves channels even if they are on different bands.

(14-Aug-2016, 08:19 PM)Oscar Wrote: The Band Scanner tends to stop in the first channels it detects power... that means it could be some channels very close to the real one in terms of frequency , even if they are in completely different band. I found I just have to keep scrolling to the next one if it's not the one.

I only have to use band scanner when i want to watch my friend flies, I save all of my own channels. The "working channel" feature is great as it saves channels even if they are on different bands.

Hey thanks for the reply,  yeah I was under the impression that if the peaks on the graph showed the strongest signal than that should be the strongest signal / channel to use.  I wish their was a good in depth video or manual explaining some of this as its a bit confusing.  On a side note,  I tested my quad at a known site with lots of interference and I was happily surprised that areas with bad reception came in much better.  I am using a LH Airblade antenna on my quad and another LH Airwave with an Immersion patch antenna on FS HD V1.     

Thanks again for the help,

Dennis