Hi friends, I have a problem with my vtx, I crashed and now i can't solder again de pigtail from the vtx because the signal point no longer exists.Someone knows another point to solder it?
The vtx is a foxeer TM25
Thanks

I'd say it's time to put that VTX in the recycling bin.

You *might* be able to remove the metal cover and extend the output track from the board inside, but the damage might already be too severe.

I had the a similar problem problem with a TM25... If mine hadn't been mounted in such a bad way I would start to think based on your post that it was a bad choice for VTx!

In the end, I got a new one... but then I had wiring issues with that one and burnt it out (melted a wire and it caused a short... really poor placement on the quad and the TM25 does get rather hot at 600mw which I've stopped using)

Then I switched to the Eachine TX801 which is smaller and I've mounted in a more appropriate position. So far no problems! I recommend it as a potential replacement

Thanks, yesterday I bought a tbs, but the problem is that where I live, it will take about 3 weeks and I did not want to be without flying

Yeah... definitely a bummer... I find myself ordering domestically more and more just because I don't want to wait. Luckily being in the US there are lots of domestic options for me.

also, Welcome to IntoFPV!

(26-Sep-2017, 05:51 PM)Carl.Vegas Wrote: Yeah... definitely a bummer... I find myself ordering domestically more and more just because I don't want to wait. Luckily being in the US there are lots of domestic options for me.

also, Welcome to IntoFPV!

Due to the ever worsening service from the post office in my country, I've started using Banggood's expedited shipping option instead. It never takes more than five days for DHL to ship my orders from China to Sweden. It doesn't actually cost that much either, normally five to ten USD.