Flashing your TX isn’t that hard you only need a data cable or as i use an Arduino mega ( Also tested with Nano watch this https://www.youtube.com/watch?v=LfZHrCZyC6o ).
Connect your Arduino with the Turnigy as shown on the pictures below.
Connect cables Tx to Tx0 , Rx to Rx0, connect ground and bridge one ground wire with the reset on arduino and follow steps below :
1. Connect Arduino to your PC.
2. Check for the COM port number assigned to Arduino under Port (COM & LPT).
3. Download from https://github.com/benb0jangles/FlySky-i6-Mod- (choose the one that suite you).
Save your settings cause you need to setup again after the update.
4. Prepare the transmitter : System – Firmware update – OK – YES.
5. Run downloaded .exe as Administrator.
6. Select COM port – Press Open Port
And now program your TX . Happy Flashing
Connect your Arduino with the Turnigy as shown on the pictures below.
Connect cables Tx to Tx0 , Rx to Rx0, connect ground and bridge one ground wire with the reset on arduino and follow steps below :
1. Connect Arduino to your PC.
2. Check for the COM port number assigned to Arduino under Port (COM & LPT).
3. Download from https://github.com/benb0jangles/FlySky-i6-Mod- (choose the one that suite you).
Save your settings cause you need to setup again after the update.
4. Prepare the transmitter : System – Firmware update – OK – YES.
5. Run downloaded .exe as Administrator.
6. Select COM port – Press Open Port
And now program your TX . Happy Flashing
Dont be Stupid , Fly safe. / BornforFPV.eu - Youtube