Hi guys maybe you will have some smart ideas what to check,
i have mounted the f303 board on a scrap xzmr, however the issue is that everytime i boot the fc (usb/battery alike) it enters boot mode...
i've uploaded new software, and after upload i can connect via betaflight config... issue is when i reboot... im again in boot mode...
what i have tested so far:
- uploaded newest betaflight 3.0
- uploaded betafligh 2.7
- checked with multimeter the "boot" buttton - when pressed there is a connection, when not no connection - so it works
at the moment i have 2 ideas:
- maybe one of ESC is sending some "stupid" signal
- board is crap (this piece)
All the best and formally hello as this is first post after few months of stalking
Grzesiek
i have mounted the f303 board on a scrap xzmr, however the issue is that everytime i boot the fc (usb/battery alike) it enters boot mode...
i've uploaded new software, and after upload i can connect via betaflight config... issue is when i reboot... im again in boot mode...
what i have tested so far:
- uploaded newest betaflight 3.0
- uploaded betafligh 2.7
- checked with multimeter the "boot" buttton - when pressed there is a connection, when not no connection - so it works
at the moment i have 2 ideas:
- maybe one of ESC is sending some "stupid" signal
- board is crap (this piece)
All the best and formally hello as this is first post after few months of stalking
Grzesiek
All the best
Grzesiek (Grisha/ Greg)
Curently flyable: Nox 5, Minimalist 112
Bench / in progres: fixing Nox 3, Scrap
thinking about building: 450
Grzesiek (Grisha/ Greg)
Curently flyable: Nox 5, Minimalist 112
Bench / in progres: fixing Nox 3, Scrap
thinking about building: 450