25-May-2017, 07:15 AM
MAJOR YAY!!!
Hey guys, I have received my Eachine goggles 2!! Thanks to BangGood, Sandra and Oscar, I will complete a full review this weekend...I have installed the Eachine PRO DVR with the switch, as per instructions from Drone Of Prey, thanks again buddy! I only had a 3 way switch and being impatient, just bridged the 2 center poles, so 2 positions are OSD on and 'up' is OSD off, I can still swap it for a 2-way though...
I have updated the firmware and read through the posts at RCGroups, but I am having continued problems with a 'fuzzy, rolling screen' with the switch in OSD 'on' position, thankfully switching OSD off still results in perfect picture!
Just wondering if anyone might have any suggestions, my buddy said that rolling screen usually comes from grounding problems but I ran out of time to pick his brain yesterday.
The switch housing is metal so I was wondering if I should run a wire from it to ground, but as I said the picture is fine with OSD off going through the same switch..?
Windless fields and smokeless builds